Lenovo ThinkSystem SR650 V2 Maintenance Manual page 384

Step 1. Touch the static-protective package that contains the new component to any unpainted surface on
the outside of the server. Then, take the component out of the package and place it on a static-
protective surface.
Step 2. Use a 5 mm wrench to install the serial port cable into the bracket.
Figure 297. Assembling the serial port module
Step 3. Install the serial port module to the riser bracket.
Figure 298. Installing the serial port module
Step 4. Install the riser assembly back to the server.
Figure 299. Installing the riser assembly
Step 5. Connect the cable of the serial port module to the serial-port-module connector on the system
board. For the location of the serial-port-module connector, refer to "System board components"
on page 53.
ThinkSystem SR650 V2Maintenance Manual
374