Step 1.
Remove the 7mm drive backplane on the top.
Figure 276. 7mm drive backplane removal (top)
a.
Remove the two screws.
b.
Vertically lift the backplane up and put it aside.
Step 2.
Remove the 7mm drive backplane at the bottom.
Figure 277. 7mm drive backplane removal (bottom)
a.
Remove the screw.
b.
Remove the backplane horizontally from the cage as shown.
After you finish
1. Do one of the following:
• If you are replacing the backplanes, install new backplanes to the drive cage.
• If you are replacing the drive cage, install the backplanes to a new drive cage.
2. If you are instructed to return the defective component, follow all packaging instructions and use any
packaging materials that are provided.
.
Chapter 4
Hardware replacement procedures
345