Required Tools And Materials - Siemens SIMATIC NET RUGGEDCOM RS401 Installation Manual

Introduction
1.3 Required Tools and Materials
Ethernet Port Status LEDs
Communication Ports
RS-232 Console Port
Failsafe Alarm Relay
Power Supply Terminal Block
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RS401:
AC or DC power cord (16 AWG)
Multi-mode and/or single-mode fiber optic cables
CAT-5 Ethernet cables
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
4
Indicate the status of the associated serial port.
Receive and transmit data, as well as provide access to the
RUGGEDCOM RS401 Web interface. For more information about
the various ports available for the RUGGEDCOM RS401, refer to
"Communication Ports" (Page
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device" (Page
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay" (Page 13)
• "Failsafe Alarm Relay Specifications" (Page 29)
A pluggable terminal block. For more information, refer
to "Connecting Power" (Page 15)
Specifications" (Page 29)
Tools/Materials
LED State
Off
Rx Blinking
Off
Tx Blinking
Off
LED State
RxX Blinking
Off
Tx Blinking
Off
21).
19).
and
For connecting power to the device.
For connecting the device to a LAN.
For connecting the device to a LAN.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
Installation Manual, 11/2022, C79000-G8976-1017-12
Meaning
No link detected
Link activity
(receive)
No link activity
Link activity
(transmit)
No link activity
Meaning
Link activity
(receive)
No link activity
Link activity
(transmit)
No link activity
"Power Supply
Purpose
RUGGEDCOM RS401