Intermediate Prop Shaft Replacement (4-Seat) - Polaris RZR PRO R Service Manual

4. Install engine mounting bracket and torque fasteners
to specification.
TORQUE
Engine Isolator Mounting Fasteners:
33 ft-lbs (45 Nm)
Engine Isolator Bracket Fasteners:
18 ft-lbs (25 Nm)
Lower Engine Mount Fasteners:
52 ft-lbs (70 Nm)
INTERMEDIATE PROP SHAFT
REPLACEMENT (4-SEAT)
REMOVAL
1. Remove front prop shaft. See Front Prop Shaft
Replacement outlined in this chapter.
2. Remove front, middle, and rear skid plates.
q
3. Remove four fasteners
shaft and bearing to the frame.
4. Remove prop shaft slip yoke from the transmission
and remove prop shaft out the bottom of the vehicle.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
retaining intermediate prop
w
5. Remove two fasteners and remove prop shaft and
bearing from the mounting bracket.
INSTALLATION
1. Install bearing onto mounting bracket. Torque
fasteners to specification.
TORQUE
Prop Shaft Bearing Fasteners:
33 ft-lbs (45 Nm)
2. Install prop shaft yoke into transmission output shaft.
FINAL DRIVE
8
8.17