Icom IC-78 Instruction Manual page 37

D
Channel setting
Both the transmit and receive, frequencies in the op-
erating channel can be entered in the VFO mode.
• Simplex channel programming
q Hold down [FC] for 1 second to enter VFO mode.
w Push [UP p] or [q DN] to select the desired chan-
nel.
• Any channels, even blank channels, can be selected.
• If you want to select the desired channel with the
Keypad, select the channel before entering the VFO
mode.
e Tune to the desired receive frequency with the
Channel Selector, or Keypad.
• Selects operating mode and other settings, such as
filter selection, RF attenuator, and so on, if necessary.
r Hold down [ENT] for 1 second
to store the frequency into the selected channel.
• Reprogram the channel name, if necessary.
• Split (duplex) channel setting
q Save receive frequency as described above.
w Push [TXF] to display the transmit frequency.
• The "TX" icon blinks.
e Tune to the desired transmit frequency with the
Channel Selector, or Keypad.
r Hold down [ENT] for 1 second
to save the transmit frequency into the selected
channel.
• The "
" icon is displayed.
D
Call channel setting
Both the transmit and receive frequencies in the Call
channel can also be entered in the VFO mode.
➥ Select channel 0 (Call channel) with the Keypad
in the Channel mode or push [UP p] or [q DN] in
the VFO mode.
• Channel 0 cannot be selected using the Channel
Selector
• When Channel 0 is selected using [CALL], the saved
frequencies cannot be preset.
• Holding down [FC] for 1 second to enter the VFO mode
when channel 0 is selected in channel mode.
(p. 33)
,
(3 beeps are emitted)
(p. 26)
(p. 33)
,
(3 beeps sound)
➥ Set the receive frequency or both the receive and
transmit frequencies, operating mode and other
settings as described above, then hold down [ENT]
for 1 second to save them in the Call channel.
5
EXTRA FEATURES
[ENT]
[FC]
[ENT]
[TXF]
34