Tamper-Evident Security Seals - Siemens SIMATIC NET Installation Manual

Cable Type Wavelength (nm) Modal Bandwidth
OM1 (62.5/125)
OM2 (50/125)
a
OM3 (50/125)
a
OM4 (50/125)
a
Laser optimized.
1.6

Tamper-Evident Security Seals

In compliance with the security requirements of the Federal Information Processing
Standards (FIPS140-2), FIPS-compliant tamper-evident security seals are applied
to potential access points on this device. Security seals provide evidence of
unauthorized tampering or removal of components.
Worn, damaged or missing seals must be replaced immediately.
Replacement seals are available for purchase from Siemens. For more information,
contact a Siemens Sales representative.
There are three ways to determine if a security seal has been tampered with:
•
•
•
For information about the placement of security seals, refer to the
"RUGGEDCOM M2100F FIPS 140-2 Non-Proprietary Security Policy [https://
support.industry.siemens.com/cs/ww/en/view/109757984]".
RUGGEDCOM M2100F
Installation Manual, 04/2022, C79000-G8976-1342-09
(MHz·km)
850 200
1300 500
850 500
1300 500
850 1500
1300 500
850 3500
1300 500
NOTICE
The seal is cut or torn
A pattern is left on the device when the top layer of the seal is removed
Residue left by the seal is visible on the device under ultra-violet light
1.6 Tamper-Evident Security Seals
Distance (m)
100Base-FX 1000Base-SX
— 275
2000
— 550
2000
— 550
2000
— 550
2000
Introduction
10GBase-SR
33
— —
82
— —
300
— —
400
— —
5