Siemens North American Electric 3RW30-40 Series Quick Start Manual

1.0 Quick Start
Contact Your Distributor If No Electrical Schematics Were Provided with Panel
1. Verify NAE Serial on Electrical Schematics matches the serial number posted inside of enclosure
2. Connect Motor Leads to U,V,W terminals on Soft Start, Torque to specification on schematic
3. Connect incoming power to line side of disconnect, torque to specifications on Electrical Schematics.
*Ensure Proper grounding per NEC and Local Code*
4. Configure any phase or voltage protection devices to the appropriate settings for your incoming power.
For MotorSaver, these instructions are posted inside of enclosure.
5. Power the panel on by moving the disconnect into the "ON" position
6. Once Powered, verify any phase or voltage protection devices are not faulted.
i.e. MotorSaver-460 status light is green. If not, refer to instructions posted in enclosure
7. Configure Soft Start parameters for Application, using the potentiometers outlined on the back of this
document.
8. To enable AUTO mode Operation, wire NO contact across terminals indicated on Electrical Schematic
9. The panel is now ready for operation
Siemens 3RW30-40 Soft Starter – Quick Start Guide
© 2020 North American Electric, Inc.
Quick Start Guide
Siemens
3RW30-40 Series
Soft Starter
naemotors.com 800.888.0404
MAN-CUST-0004
REV 1.2
1