Maintenance - Husqvarna 522iHD60 Operator's Manual

To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides.
2. Adjust the speed to align with the work load.
3. Hold the product near your body for a stable work
position.
4. Make sure that the tip of the cutting equipment does
not touch the ground.
5. Be careful and work slowly until all the branches are
correctly cut.
To select the cutting speed
The product has a mode button. With the mode button
the operator can limit the maximum speed. The mode
button has 3 speed levels. A lower level increases the
time of operation for the product. Use level 1 and level
2 if the operation does not require full speed/full power.
If the operation condition requires full speed/full power,
use level 3. Do not use a higher level than necessary for
the operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on.
2. Press the Mode button again to choose the next
speed level.
Introduction
WARNING:
safety chapter before you do maintenance
work on the product.
32

Maintenance

Read and understand the
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
30 minutes.
To adjust the angle of the rear handle
To get the best operation position, the rear handle
can be adjusted in 5 different positions. If the angle is
adjusted, make sure that the bottom of the rear handle
points down when you operate the product.
1. Release the handle lock and turn the handle.
WARNING:
cutting attachment when you adjust the
handle.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED goes
out.
3. Push the release buttons on the battery and pull the
battery out.
WARNING:
you do maintenance on the product.
Do not operate the
Remove the battery before
1731 - 003 - 12.10.2022