Table of Contents
Advertisement
•
A defective or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
•
Make sure that you assemble the cover and shaft
correct before you start the product.
•
The drive disc and support flange must engage
correctly in the centre hole of the cutting attachment.
A cutting attachment that is attached incorrectly can
cause injury or death.
•
To operate the product safely and prevent injury
to the operator or other persons, the product must
always be attached correctly to the harness.
Assembly of blades and trimmer heads
WARNING:
cutting attachment it is very important that
the raised section on the drive disc/support
flange engages correctly in the centre hole
WARNING:
instructions that follow before you do
maintenance on the product.
•
Remove the battery before you do maintenance,
other checks or assemble the product.
•
The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
•
Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
•
If you do not do maintenance, it decreases the
life cycle of the product and increases the risk of
accidents.
Introduction
WARNING:
safety chapter before you assemble the
product.
12
When you install the
Safety instructions for maintenance
Read the warning
Assembly
Read and understand the
of the cutting attachment. If the cutting
attachment is install incorrectly it can result
in serious and/or fatal personal injury.
WARNING:
attachment without an approved guard. See
the chapter on Technical data. If an incorrect
or faulty guard is fitted this can cause
serious personal injury.
•
Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
•
Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
•
Only use original spare parts.
•
Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
2. Tighten the knob lightly.
Never use a cutting
757 - 008 - 16.02.2024
Advertisement
Table of Contents
