Table of Contents
Advertisement
5 Installation
5.1 Electrical connection
Electrical voltage
Danger of electrocution
• Have the electrical connection
performed by authorised technical
personnel.
• The appliance must be connected to
earth in compliance with electrical
system safety standards.
• Disconnect the mains supply.
General information
Check the mains supply characteristics
against the data indicated on the plate.
The identification plate bearing the
technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
The appliance operates at 220-240 V~.
Use a three-core cable (3 x 1.5 mm
internal conductors).
Perform the ground connection using a wire
that is 20 mm longer than the other wires.
46
Installation
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters, gang sockets or
extensions as these could cause
overheating and a risk of burns.
5.2 Cable replacement
• Disconnect the mains supply.
1. Unscrew the rear casing screws and
remove the casing to access the terminal
board.
2
2. Replace the cable.
3. Make sure that the cables (for the oven
or any hob) follow the best route in order
to avoid any contact with the appliance.
Electrical voltage
Danger of electrocution
Advertisement
Table of Contents
