5.
Installation of the narrow stitching heads 70/20
Insert key blocks 1 into the traverses 2 . Milled part must point downwards.
Install the stitching head with the boring over the peg of the key blocks 1 , at the
same time also align the driving block 3 , the pusher 4 and adjusting block 5 with
the corresponding rails. Clamp the stitching head to the machine by turning down the
hex sockets 6 of the eccentric until it is tight.
Hohner Maschinenbau GmbH – ORION 4
- 8 -