Table of Contents
Advertisement
Structure and function of the machine
3.5
Installation of the narrow stitching heads 70/20
- Fig. 3.5 -
- Insert key blocks -1- into the traverses -2- .
Milled part must point downwards!
- Install the stitching head with the boring over the peg of the key blocks -1- , at the same time also
align the driving block -3- , the pusher -4- and adjusting block -5- with the corresponding rails.
- Clamp the stitching head to the machine by turning down the hex sockets -6- of the eccentric until
it is tight.
20
ORION 4
10/2010
Hohner Maschinenbau GmbH
Advertisement
Table of Contents
