Settings - Aprilaire S86N MU Manual

TABLE 1 – HVAC INSTALLER SYSTEM SETTINGS
System setting Description
Select No to skip the rest of the
Advanced HVAC

Settings?

thermostat settings
Progressive
Enables or disables progressive recovery
Recovery
Select if the Heat Blast option is
Display Heat Blast?
displayed
Amount of heating when Heat Blast is
Heat Blast Offset
initiated
Extended Fan – Extends fan operation 90 seconds after
Heat heat call ends
Extended Fan – Extends fan operation 90 seconds after
Cool cool call ends
Enable or disable Auto Changeover
Auto Changeover
mode
20
Factory default setting
(bold) and setting range
No
Yes
Disabled
Enabled
No
Yes
3°F (1.5°C)
4°F (2°C)
5°F (25°C)
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
TABLE 1 – HVAC INSTALLER SYSTEM SETTINGS
System setting Description
DeadBand Auto Changeover mode deadband
Auto Changeover Minimum time between heating and
Time cooling calls
Field adjustment of controlling
Temp Sensor Offset
temperature sensors
Internal RH sensor Increases or
RH Sensor Offset
decreases displayed RH%
Equipment Minimum on time for heating and
Minimum On Time cooling
Heating Minimum
Minimum off time for heating
Off Time
Compressor Minimum off time for compressor
Minimum Off Time protection
Factory default setting
(bold) and setting range
3°F (1.5°C)
2 to 9°F (1 to 45°C)
4 Minutes
1 to 5 Minutes
0°F (0°C)
-4 to 4°F (-2 to +2°C)
0
-5 to 5
2 Minutes
1 to 5 Minutes
2 Minutes
1 to 5 Minutes
5 Minutes
1 to 5 Minutes
21