Download Print this page
Exmark Quest 42 Installation Instructions

Exmark Quest 42 Installation Instructions

Mulch kit

Advertisement

Quick Links

Mulch Kit Quest
Kit No. 116-9414
For Serial Nos. 313,000,000 & Higher
This product contains a chemical or chemicals known to the State of California to
Safety Alert Symbol
This Safety Alert Symbol (Figure 1) is used both in this
instruction sheet and on the machine to identify important
safety messages which must be followed to avoid accidents
This symbol means: ATTENTION! BECOME ALERT!
YOUR SAFETY IS INVOLVED!
Safety Alert Symbol
The safety alert symbol appears above information which
alerts you to unsafe actions or situations and will be followed
by the word DANGER, WARNING, or CAUTION.
DANGER: White lettering / Red background. Indicates an
imminently hazardous situation which, if not avoided, Will
result in death or serious injury.
WARNING: Black lettering / Orange background. Indicates
a potentially hazardous situation which, if not avoided, Could
result in death or serious injury.
CAUTION: Black lettering / Yellow background. Indicates
a potentially hazardous situation which, if not avoided, May
result in minor or moderate injury.
This manual uses two other words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
© 2012—Exmark Mfg. Co., Inc.
Industrial Park Box 808
Beatrice, NE 68310
®
42
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Figure 1
www.Exmark.com
WARNING
CALIFORNIA
WARNING
While maintenance or adjustments are being made,
someone could start the engine. Accidental starting
of the engine could seriously injure you or other
bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance. Also push
the wire(s) aside so it does not accidentally contact
the spark plug(s).
Note: Determine the left and right sides of the machine
from the normal operating position.
Form No. 4501-514 Rev A
Installation Instructions
Original Instructions (EN)
All Rights Reserved *4501-514* A
Printed in the USA

Advertisement

loading

Summary of Contents for Exmark Quest 42

  • Page 1 This manual uses two other words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. © 2012—Exmark Mfg. Co., Inc. www.Exmark.com Original Instructions (EN) All Rights Reserved *4501-514* A Industrial Park Box 808...
  • Page 2 Loose Parts Use the chart below to verify that all parts have been shipped. Item Part No. Description Item Part No. Description 121-5691-03 Asm-Baffle 3230-1 Bolt-Carriage 5/16-18 x 3/4 106-2247-03 Blade 104-8300 Nut-Nyloc 5/16-18 Flg 121-5690-03 Asm-Kicker Figure 2...
  • Page 3 Installation Instructions WARNING 1. Make sure all moving parts have stopped, parking brake Open holes in the mower expose you and is engaged, and the key has been removed. others to thrown debris which can cause severe injury. 2. Raise the front end of the machine and support with jack stands.
  • Page 4 Note: Refer to the Operator’s manual for blade maintenance. 12. Carefully remove the jack stands and lower the unit to the ground. Reinstall the spark plug cable(s) and ignition key. Your Exmark unit has successfully been converted to a mulching mower.

This manual is also suitable for:

116-9414