Removing The Processor - Dell Studio One 19/1909 Service Manual

Back to Contents Page
Processor
Dell Studio One 19/1909 Service Manual
Removing the Processor
Replacing the Processor
WARNING:
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
incorrectly could damage your system board. For technical service information, see the Setup Guide.
Removing the Processor
1. Follow the procedures in
2. Remove the computer cover (see
3. Remove the shield (see
4. Remove the stand (see
5. Remove the back I/O panel (see
WARNING:
6. Remove the processor heat sink (see
NOTE:
7. Press and push the release lever down and out to release it from the tab that secures it.
8. Open the processor cover.
1 processor cover
3 processor socket 4 release lever
CAUTION:
socket.
9. Lift up the processor to remove it from the socket, place it aside in a safe and secure place.
Great user manuals database on
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps
Before You Begin.
Removing the Computer
Removing the Shield).
Removing the Stand).
Removing the Back I/O
The heat sink may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.
Removing the Heat
Unless a new heat sink is required for the new processor, reuse the original heat sink when you replace the processor.
2 processor
When removing or replacing the processor, do not touch any of the pins inside the socket or allow any objects to fall on the pins in the
UserManuals.info
Cover).
Panel).
Sink).