Clearing Cmos Settings - Dell Studio One 19/1909 Service Manual

6. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.
7. Wait for approximately five seconds to clear the password setting.
8. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.
9. Replace the stand (see
10. Replace the shield (see
11. Replace the computer cover (see
12. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
WARNING:
WARNING:
1. Follow the procedures in
2. Remove the computer cover (see
3. Removing the shield (see
4. Remove the stand (see
5. Remove the back I/O panel (see
6. Locate the 3-pin CMOS connector (CLR_CMOS) on the system board (see
Great user manuals database on
Replacing the Stand).
Replacing the Shield).
Replacing the Computer
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
The computer must be disconnected from the electrical outlet to clear the CMOS setting.
Before You Begin.
Removing the Computer
Removing the Shield).
Removing the Stand).
Removing the Back I/O
UserManuals.info
Cover).
Cover).
Panel).
System Board Components).