Important Safety Instructions; Important Notices - Bosch MIC inteox 7100i Installation Manual

MIC inteox 7100i
1.4

Important Safety Instructions

Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems accepts no liability for any damages or
losses caused by incorrect or improper installation.
Notice!
i
Outdoor installation
For details about the proper configuration for installing your camera outdoors with surge and
lightning protection, refer to Best Practices for Outdoor Installation.
Notice!
Ancillary power (UPS) required
i
To meet the Mains Supply Voltage Dips and Short Interruptions requirements per EN 50130-4
Alarm Standard, ancillary equipment (for example, an Uninterruptible Power Supply (UPS)) is
necessary. The UPS must have a Transfer time between 2-6 ms and Backup Runtime of
greater than 5 seconds for the power level as specified on the product data sheet.
–
Notice!
i
To maintain the Type 6P rating when the camera is mounted to a MIC-DCA, installers must
make sure that the user-supplied cable glands or conduit connections have Type 6P ratings.
Warning!
Risk of bodily injury
!
Do not put a canted (35°) camera in an upright position on the camera base or on an
unsecured DCA. In this position, the camera can fall over and can cause injury or be damaged.
Put the canted camera on its side until installation.
Notice!
i
Risk of injury or damage
To prevent injury to your hands or damage to the wiper, do not touch the wiper with your
hands, especially when the wiper is moving.
1.5

Important Notices

Adjustment of controls - Adjust only those controls specified in the operating instructions.
Improper adjustment of other controls may cause damage to the unit.
Bosch Security Systems
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
Make sure that the installation conditions comply with the specified stresses of vibration
and shock as mentioned in the datasheet.
Accessories - Do not place this unit on an unstable stand, tripod, bracket, or
mount. The unit may fall, causing serious injury and/or serious damage to
the unit. Use only with mounting solutions specified by the manufacturer.
When a cart is used, use caution and care when moving the cart/unit
combination to avoid injury from tip-over. Quick stops, excessive force, or
uneven surfaces may cause the cart/unit combination to overturn. Mount the
unit per the installation instructions.
Installation Manual
Safety | en 7
2022-09 | 2.1 |