28
en | (Optional) Installing an SD card
7
(Optional) Installing an SD card
The steps that follow are applicable for enhanced models of MIC cameras.
1.
2.
3.
4.
5.
6.
7.
2022-09 | 2.1 |
Use a T20 Torx driver to remove the two (2) fasteners from the SD card cover on the rear
of the camera head.
Pull off the SD card cover. Allow the cover and the O-ring seal to hang loose from the
tether.
Note: Do not drop the fasteners.
Install a standard SD card.
If necessary, put the O-ring seal into the cover.
Put on the cover.
Install the two (2) fasteners that you removed in step 1.
Tighten the fasteners to 1.8 N m (1.3 ft lb).
Installation Manual
MIC inteox 7100i
Bosch Security Systems