Mackie X.200 User Manual page 29

• Sets the selected channel faders to off.
• Affects faders only (including Master L/R faders).
Does not affect any other channel parameters.
• This features provides a means to shift chan-
nels in time, relative to each other.
• Select the channels that will remain at the
original position; all unselected channels will
be offset by the selected number of samples
(±255).
• Use to compensate for phase and timing dis-
crepancies in a synchronization scenario or any
multitrack playback/record device setup.
• For example, if you place a plug-in with 100
samples of delay on a channel, the audio will be
behind the rest of the channels by that amount.
To compensate, you would select the channel,
choose "Adjust Channel Delay" and enter a
value of 100.
• The Channel Delay control appears in the As-
sign window for the selected channel.
• This resets the delay to 0 ms on the selected
channels.
• To reset all channels, Select All Faders
(Alt+Shift+A), then select Reset Channel Delay.
• Resets the selected channels to their default
settings (L/R assign, Level to Tape and Digital
Trim to 0 dB, EQ on and fl at, Auxes off, Pan
centered, Fader off, Gate and Compressor off
and at default settings).
• Selects all 24 channels in the currently selected
fader bank for clipboard, automation, and other
operations pertaining to multiple channel modi-
fi cations.
• Selects all 118 channels in fi ve fader banks (not
counting MIDI) for clipboard, automation, and
other operations pertaining to multiple channel
modifi cations.
The Options menu contains:
Solo Latch
Automation
Transport
Meters
DAW Emulation Mode
Faders To Tape
Route to Bank
Bank to Outputs
• When Solo Latch is selected (a checkmark ap-
pears next to Solo Latch in the Options menu),
you can solo more than one channel at a time.
• When Solo Latch is off, only one channel may
be soloed at a time.
• You can manually solo more than one channel
when Solo Latch is off by pressing the Shift key
while soloing multiple channels.
Bypass
• Selecting this option mirrors the BYPASS but-
ton on the console.
• When Bypass is selected, automation data is
neither recorded nor played back.
• When Bypass is not selected, all write-selected
parameter adjustments are written into automa-
tion data and referenced to time code.
Trim
• Selecting Trim mirrors the TRIM button on the
console.
• Sets all faders to unity position (when "Trim
From Unity" is selected in the Windows < Auto-
mation window) and assigns all parameter con-
trols (except mutes) to globally add or subtract
from existing settings and recorded moves.