Agilent Technologies E444 AU Series Installation Manual page 15

E444xAU IF Output Options
5. Remove the chassis cover, using a #10 Torx driver. Refer to
screws. There are ten screws to remove from the "speaker" side of the chassis cover and
two screws from the "power supply" side of the chassis cover. Place all hardware in a
safe location for re-installation.
NOTE The E4446A and E4468A have two additional screws in the chassis cover. The
white circles indicate the approximate position.
Figure 4 Chassis Cover Screw Location
Installation Guide
E444xAU Options H20, H25 and H70
Installation Procedure
Figure 4 for location of top
7