Graco 24B327 Operation Manual page 6

Setup
Setup
Make sure pressure control is turned off and gasoline
engine is shut off or power cord is unplugged from power
source. Refer to your sprayer operation manual for
priming and spray instructions.
Airless Spray Setup
Connect Applicator to Sprayer
1. Attach supply hose to sprayer fluid outlet.
2. Attach other end of supply hose to applicator swivel
(19).
3. Refer to sprayer operation manual for priming
instructions.
Install Fluid Filter or Plug
1. When spraying fluids with small aggregates, install
filter support (21) and filter (20, 20a) to reduce tip
clogging.
2. When spraying with large spray tips and fluids with
large aggregates, install plug (20b) to prevent fluid
from entering air passage in housing (1).
6
Install Applicator Tip and Guard
1. If equipment has recently been operated, perform
Pressure Relief Procedure, page 4.
To avoid serious injury from skin injection, do not put
your hand in front of the spray tip when installing or
removing the spray tip and tip guard.
2. Using a pencil or similar object, insert seal (25) into
back of guard (32).
3. Insert guard (32) into end of applicator.
4. Insert tip (31) in guard (32). Tighten retaining nut.
Air Spray Setup
Connect Applicator to Sprayer
1. Attach supply hose to sprayer fluid outlet.
2. Attach other end of supply hose to applicator swivel
(19).
3. Install air hose to applicator check valve (15).
4. Refer to sprayer operation manual for priming
instructions.
Install Applicator Air Nozzle
1. If equipment has recently been operated, perform
Pressure Relief Procedure, page 4.
2. Install air nozzle (10, 27, 28, 29) and retaining ring
(11).
313537E