Table of Contents
Advertisement
Operation
Airless Spray
1. Be sure the arrow shaped tip (31) faces forward
(spray).
2. Hold applicator perpendicular and approximately
40 in. (1 m) from surface. Move applicator first, then
open applicator to spray a test pattern.
3. Slowly increase pump pressure until coverage is
uniform and even (see sprayer instruction manual
for additional information).
Aligning Spray
1. Perform Pressure Relief Procedure, page 4.
2. Loosen guard retaining nut.
3. Align guard (32) horizontally to spray a horizontal
pattern.
4. Align guard (32) vertically to spray a vertical pattern.
(3) Horizontal
ti11908a
Clear Tip Clog
To avoid tip clogs:
•
When the applicator is not in use for extended
periods of time, keep the tip "wet" and perform
Pressure Relief Procedure, page 4.
•
Keep tip clean and free of material.
1. Rotate SwitchTip to unclog position. Aim applicator
at floor and turn applicator ON. When clog clears,
turn applicator OFF.
313537E
(4) Vertical
ti11909a
2. Rotate SwitchTip back to spray position. Turn
applicator ON. Spray test pattern.
UNCLOG
SPRAY
Air Spray
1. Set material flow (see sprayer instruction manual for
additional information).
2. Spray test pattern
3. Turn air knob on and adjust, and/or select another
air nozzle, for desired pattern.
Cleanup
Thoroughly flush applicator after each work session
before fluid begins to cure in applicator. Remove check
valve (2) and clean all residue from air passages. Store
in a dry location. Do not leave the applicator or any parts
in water or cleaning solvents.
NOTE: Check valve (15) will be damaged if any object is
inserted into valve.
Operation
7
Advertisement
Table of Contents
