Siemens SIMATIC S7-300 Getting Started page 28

Learning units
3.10 9. Step: Configuring the drive with SimoComU
Step Activity
12 Select the Commissioning > Configuration views >
PROFIBUS configuration menu command.
Under "Select message", enter message "102".
The PROFIBUS node address may have to be compared.
13 Select the Commissioning > Further parameters > Expert
list menu command.
Under the number "880", enter the "PROFIBUS speed
calculation" of your motor.
14 Select the Operate > Master control for PC menu command
in order to obtain the master control on your drive.
15 Select the menu command File > Save in drive to save the
data in the drive.
16 Select the menu command File > Save as file to save the
data as a file.
17 Repeat steps 4 to 16 for an existing second axis.
Select the Commissioning > Configuration views >
Configuration menu command.
18 In the browser, select the Drive B - A entry
28
Result
You have now entered the telegram type you
have previously set in HW Config.
You have now stored the rated speed data
of your motor.
The drive is now no longer controlled directly
at your PG/PC.
The configuration for drive B is opened.
CPU 317T-2 DP: Controlling a physical axis
Getting Started, 03/2008, A5E00251786-05