ECS P4S8A Manual page 21

3. In the system chassis, remove the blanking plate from the
corresponding expansion slot you want to use, and install an
extension bracket in there. Secure the extension bracket in the
chassis with a screw.
Extended IEEE1394a Header (Optional)
You can obtain one IEEE1394a header. Install them by following
the steps below.
1
IEEE1394a
IEEE1394a
Pin Signal
1 CPWR
3 XTPB0M
5 XTPA0M
7 SHIELD
1. Locate the IEEE1394a header on the mainboard.
2. Plug the bracket cable onto the IEEE1394a header.
3. In the system chassis, remove the blanking plate from the
corresponding expansion slot you want to use, and install
an extension bracket in there. Secure the extension bracket
in the chassis with a screw.
2: Mainboard Installation
Pin Signal
2 GND
4 XTPB0P
6 XTPA0P
8 KEY
17