Power Injector Led Indicators - Cisco Aironet 1400 Series Installation Manual

Chapter 5 Troubleshooting
The bridge uses a blinking code to identify various error conditions. The code sequence uses a two-digit
diagnostic code that starts with a long pause to delimit the code, followed by the indicator flashing red
to count out the first digit, then a short pause, followed by the indicator flashing red to count out the
second digit (see
Table 5-4
Indicator
Ethernet
Radio

Power Injector LED Indicators

The power injector contains three LED indicators to provide status information on the wired Ethernet
link, the bridge Ethernet link, and the bridge status. When the power injector is powered up, it sends a
constant discovery tone on the dual-coax cables to the bridge. When the bridge is connected to the
dual-coax cables, it returns the discovery tone to the power injector. When the power injector detects the
returned discovery tone, it applies +48 VDC to the dual-coax cables to the bridge.
When power is applied to the bridge, the bridge activates the bootloader and begins the POST operations.
The bridge begins to load the IOS image when the Post operations are successfully completed. Upon
successfully loading the IOS image, the bridge initializes and tests the radio.
OL-4072-01
D R A F T - C I S C O C O N F I D E N T I A L
Table 5-4).
Bridge LED Blinking Error Codes
Blinking Codes
First Second
Digit Digit
2 1
1 2
1 3
1 4
1 5
1 6
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
Description
Ethernet cable problem—Verify that the cable is properly
connected and not defective. This error might also indicate a
problem with the Ethernet link. If the cable is connected
properly and not defective, contact technical support for
assistance.
Radio not detected—Contact technical support for
assistance.
Radio not ready—Contact technical support for assistance.
Radio did not start—Contact technical support for
assistance.
Radio failure—Contact technical support for assistance.
Radio did not flash its firmware—Contact technical support
for assistance.
Power Injector LED Indicators
5-5