Checking The Led Indicators - Cisco Aironet 1400 Series Installation Manual

Checking the LED Indicators

Checking the LED Indicators
If your bridge is not associating with the remote bridge, check the four LED indicators on the back panel.
You can use them to quickly assess the unit's status.
Figure 5-1
1
2
The indicators signals have the following meanings (for additional details refer to
•
•
•
•
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
5-2
D R A F T - C I S C O C O N F I D E N T I A L
Bridge LED Indicators
Ethernet LED
Status LED
The status indicator signals bridge association status. Blinking green indicates that the bridge is not
associated with another bridge. Steady green indicates that the bridge is associated with at least one
other bridge. This indicator also provides signal strength readings during installation mode.
The radio indicator blinks green to indicate radio traffic activity. The light is normally off, but it
blinks green whenever a packet is received or transmitted over the bridge radio link. This indicator
also provides signal strength readings during installation mode.
The Ethernet indicator signals Ethernet traffic. This indicator blinks green when a packet is received
or transmitted over the Ethernet infrastructure. The indicator is off when the Ethernet link not
working or the port is shutdown. This indicator also provides signal strength readings during
installation mode.
The install indicator provides installation mode association status. During installation mode, the
other indicators provide signal strength readings used for antenna alignment.
Figure 5-1 shows the indicators.
3
1
2
3 Radio LED
4
Install LED
Chapter 5 Troubleshooting
4
Table 5-3):
OL-4072-01