Cisco Aironet 1400 Series Installation Manual page 21

Chapter 1 Overview
Table 1-1 Bridge, Power Injector, and Power Module Specifications (continued)
Category
Connectors
Operating Temperature
Cold Start Temperature -22
Warm-up time
(for full performance)
Non-Operational
Temperature
Operational Altitude
Non-Operational
Altitude
Humidity
Operational Vibration
Non-Operational
Vibration
Environmental Testing
Compliance
Weight
Input Voltage
Power Consumption
Transmit Power
Frequency
Wireless modulation
OL-4072-01
D R A F T - C I S C O C O N F I D E N T I A L
Bridge
Bottom panel (left to right): Ethernet port1 and port 2
(two F-type connectors), RSSI port (male BNC
connector)
Front Panel (external antenna configuration):
antenna Type N connector
o o
–22 to 131 F (–30 to 55 C)
o o
F (-30 C)
15 minutes after cold start
o o
–40 to 185 F (–40 to 85 C)
6,562 ft (2000 m)
16,000 ft (4877 m)
0 to 100% (condensing)
2
0.001 G /Hz from 5-100 Hz
2
0.01 G /Hz from 5-100 Hz
Integrated antenna configuration:
The enclosure has been successfully tested for
protection against the ingress of particulate
matter and fluids in compliance with a NEMA
Type 4 (IP56) enclosure rating.
External antenna configuration:
The enclosure has been successfully tested and is
in compliance with a NEMA Type 4 (IP56)
enclosure rating.
Integrated antenna configuration:
11 lbs (4.99 kg)
External antenna configuration:
10 lbs (4.54 kg)
48 VDC nominal (supplied by Ethernet dual-coax
cables)
41 W (typical)
TBD W (maximum)
24, 23, 22, 21, 18, 15, 12 dBm
UNII 3—5.725 to 5.825 GHz
(Depending on the regulatory domain)
Coded Orthogonal Frequency Division Multiplexing
(COFDM)
Power Injector
Side panel (left to right): 48VDC power
connector, two coaxial uplink F-type
connectors, and Ethernet RJ-45 connector
for 100BASE-T Ethernet
32 to 122
na
na
-40 to 158
6,562 ft (2000 m)
16,000 ft (4877 m)
0 to 90% (non-condensing)
0.001 G
0.01 G
na
Power injector—1.4 lbs (0.6 Kg)
Power
Power injector—48 VDC nominal
Power module—100-240 VAC
TBD
na
na
na
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
Bridge Specifications
o o
F (0 to 50 C)
o o
F (-40 to 70 C)
2
/Hz from 5-100 Hz
2
/Hz from 5-100 Hz
Module—TBD
W (maximum)
1-7