2.2
Formatted capacity
ST models
ST10000VE000
ST8000VE000
* One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
2.2.1
LBA mode
When addressing these drives in LBA mode, all blocks (sectors) are consecutively numbered from 0 to n–1, where n is the number of
guaranteed sectors as defined above.
See
Section 4.3.1, "Identify Device command"
support of drives with capacities over 137GB.
2.3
Recording and interface technology
Interface
Recording method
Recording density, KBPI (Kb/in max)
Track density, KTPI (ktracks/in, 0 Skew)
2
Areal density (Gb/in
, @ 0 skew mid-disk)
Spindle speed (RPM) (± 0.2%)
Internal data transfer rate (Mb/s max)
Sustained data transfer rate (MiB/s max)
I/O data-transfer rate (MB/s max)
2.4
Start/stop times
Power-on to ready time is based on typical operating conditions, default full current spin-up profile, and clean shutdown prior to
measurement. To ensure a clean shutdown a Flush Cache, Standby, or Standby Immediate command must be completed before
removal of interface power.
Power-on to Ready (sec) (typ/max)
Standby to Ready (sec) (typ/max)
Ready to spindle stop (sec) (max)
An unexpected power loss event, spin up at cold or hot temperature extremes may cause the drive to exceed the typical and max
time to ready by 5 to 20 seconds. Extended time to ready is dependent on cache state and environmental conditions prior to the
unexpected power loss and during the subsequent power on.
Seagate SkyHawk AI Serial ATA Product Manual, Rev. B
Formatted capacity*
10TB
8TB
(words 60-61 and 100-103) for additional information about 48-bit addressing
Serial ATA (SATA)
Perpendicular
2499
487
1215
7200
2169
238 (250 MB/s max)
600 (Ultra DMA mode 5)
23/30
23/30
20
Guaranteed sectors
Bytes per logical sector
19,532,873,728
15,628,053,168
512
8