Table of Contents
Advertisement
Drive specification
Altitude, nonoperating
(below mean sea level, max)
Operational Shock (max at 2 ms - typical)
Non-Operational Shock (max at 2 ms - typical)
Vibration, operating
Operation Rotational vibration
Vibration, nonoperating
Drive acoustics, sound power (bels)
Idle
Performance seek
Nonrecoverable read errors
Annualized Failure Rate (AFR)
*
Maximum Rated Workload
Warranty
Load-unload cycles
(command controlled)
Supports Hotplug operation per
Serial ATA Revision 3.3 specification
#
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
*
See
Section 2.11, "Reliability"
2.2Formatted capacity
ST models
ST8000VE000
ST6000VE000
*
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
2.2.1
LBA mode
When addressing these drives in LBA mode, all blocks (sectors) are consecutively numbered from 0 to n–1, where n is the number of
guaranteed sectors as defined above.
See
Section 4.3.1, "Identify Device command"
support of drives with capacities over 137GB.
Seagate SkyHawk AI Serial ATA Product Manual, Rev. D
During periods of drive idle, some offline activity may occur according to the
SMART specification, which may increase acoustic and power to operational levels.
*
Maximum rate of <550TB/year
Workloads exceeding the annualized rate may degrade the drive MTBF and impact product
reliability. The Annualized Workload Rate is in units of TB per year, or TB per 8760 power on
hours. Workload Rate = TB transferred * (8760 / recorded power on hours).
To determine the warranty for a specific drive, use a web browser to access the following
web page: http://www.seagate.com/support/warranty-and-replacements/.
From this page, click on the "Is my Drive under Warranty" link. The following are required to
be provided: the drive serial number, model number (or part number) and country of
purchase.The system will display the warranty information for the drive.
for rated MTBF device operating condition requirements.
Formatted capacity*
(words 60-61 and 100-103) for additional information about 48-bit addressing
ST8000VE000
–304.8 m to 12,192 m
(–1000 ft to 40,000+ ft)
Read 70 Gs / Write 40 Gs
300 Gs
5–22 Hz:
0.25 Gs, Limited displacement
22–350 Hz: 0.50 Gs
350–500 Hz: 0.25 Gs
20–1500Hz: 12.5 rads/s²
10–500 Hz: 5.0 Grms ref
2.8 (typical)
3.0
3.2 (typical)
3.4
1 sector per 10
0.44% based on 8760 POH
300,000
Yes
Guaranteed sectors
8TB
15,628,053,168
6TB
11,721,045,168
ST6000VE000
(max)
(max)
15
bits read
Bytes per logical sector
512
7
Advertisement
Table of Contents
