Table of Contents
Advertisement
Drive specification
Altitude, nonoperating
(below mean sea level, max)
Operational Shock (max at 2 ms - typical)
Non-Operational Shock (max at 2 ms - typical)
Linear Random Operating Vibration
Random Rotary Operating Vibration
Linear Random Non-Operating Vibration
Drive acoustics, sound power (bels)
Idle
Performance seek
Nonrecoverable read errors
Annualized Failure Rate (AFR)
*
Maximum Rated Workload
Warranty
Load-unload cycles (command controlled)
Supports Hotplug operation per
Serial ATA Revision 3.3 specification
#
One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting.
* See
Section 2.10, "Reliability"
** See
Section 2.4, "Start/stop times"
†
Seagate does not recommend operating at sustained case temperatures above 60°C.
Operating at higher temperatures will reduce useful life of the product.
# The operating temperature is 0 to 65°C (32 to 149°F).
If the drive is powered-off before issuing flush cache command, in some instances,
Note
the end user data in the DRAM cache might not be committed to the disk.
Seagate SkyHawk AI Serial ATA Product Manual, Rev. B
During periods of drive idle, some offline activity may occur according to the
SMART specification, which may increase acoustic and power to operational levels.
*
Maximum rate of <550TB/year
Workloads exceeding the annualized rate may degrade the drive MTBF and impact product
reliability. The Annualized Workload Rate is in units of TB per year, or TB per 8760 power on
hours. Workload Rate = TB transferred * (8760 / recorded power on hours).
To determine the warranty for a specific drive, use a web browser to access the following
web page: www.seagate.com/support/warranty-and-replacements/.
From this page, click on the "Is my Drive under Warranty" link. The following are required to
be provided: the drive serial number, model number (or part number) and country of
purchase.The system will display the warranty information for the drive.
for rated MTBF device operating condition requirements.
for additional information.
ST10000VE000
–304.8 m to 12,192 m
(–1000 ft to 40,000+ ft)
Read 70 Gs / Write 40 Gs
300 Gs
10–500 Hz:
20–1500Hz: 12.5 rads/s²
10–500 Hz: 2.0 Grms ref
2.8 (typical)
3.0
3.2 (typical)
3.4
1 sector per 10
0.58% based on 8760 POH
600,000
Yes
ST8000VE000
1.04Grms
(max)
(max)
15
bits read
7
Advertisement
Table of Contents
