Design Features; Controls And Settings - Lincoln Electric Ranger 305D Service Manual

B-3

DESIGN FEATURES

• Single, full-range output control dial.
• 4 welding modes: CC-stick, downhill stick welding on
pipe, CV wire welding and Touch-Start TIG
nates high frequency and tungsten contamination).
• Output at welding terminals controlled by electronic
contactor. Can be switched to "On", or to "Remotely
Controlled".
• Many wire feeder combinations: 14-pin connector for
Lincoln wire feeders LN-25, LN-23P, LN-7, LN-8 oper-
ates when using a Lincoln wire feeder with the appro-
priate control cable.
• Smart machine! Remote operation and Magnum
spool gun; 42VAC for LN-742 and Cobramatic
feeders.
• 12 gallon fuel capacity allows you to run an extended
day.
• Easily check fuel level during operation and refuelling
with highly visuable fuel gauge.
Some models have gauge located next to fuel cap on
case top.
Some models have gauge located on front panel.
• Voltmeter and ammeter display actual volts and amps
at output terminals when welding.
OPERATION
All manuals and user guides at all-guides.com
(elimi-
TM
®
wire
®
RANGER 305D
• Longer engine life, reduced noise emissions and
great fuel economy with the automatic engine idler.
• Conveniently located engine maintenance label under
top engine door.
• Engine hour meter for scheduled maintenance.
• Electric start.
• Oil drain valve (no tools required).
• See spec pages for watts of continuous duty AC gen-
erator power.
• See spec pages for Amp and voltages output specs.
Circuit breaker protection.
• See spec pages for receptacle information.
CONTROL AND SETTINGS
The diesel engine stop/start and idler controls are
located on the case front panel. The welder controls
are also located here. See Figure B.1.
B-3