Table of Contents
Advertisement
Set up (Continued)
Voicemail voltage detection
There are 3 options to set the voicemail voltage detection at the bottom side of the telephone
base.
To disable the voicemail voltage detection:
1. Use a narrow object to unplug all the jumpers from the telephone base.
To set the voicemail voltage detection by the periodic low voltage pulse
detection method:
1. Use a narrow object to unplug all the jumpers from the telephone base.
Then plug the jumpers into
To set the voicemail voltage detection by the steady high voltage and periodic high voltage pulse
detection method:
1. Use a narrow object to unplug all the jumpers from the telephone base.
Then plug the jumpers into
Speed Dial keys
There are up to 10 programmable guest-service (Speed Dial) keys, including MESSAGE and
EMERGENCY speed dial keys. Program these keys to automatically dial telephone numbers or to
activate telephone system features.
To program a Speed Dial key:
1. Remove the faceplate and overlay if they are on the telephone base. Press
telephone base or lift the handset. Then press the recessed PROGRAM key. The MUTE key
flashes when in administrator mode.
2. Press the desired Speed Dial key where the telephone number is to be stored. You hear 3
beeps.
3. Enter the telephone number (up to 16 digits).
• To insert a pause in the stored number, press the recessed PAUSE key.
4. The telephone stores the number automatically when 16 digits are entered. When the number
has less than 16 digits, press the recessed PROGRAM key again. You hear 3 rising beeps as
confirmation.
1
,
2
and
3
.
1
,
2
and
4
.
EN - 15
Jumper
1
2
3
4
on the
Advertisement
Table of Contents
