Analog corded lobby hotel telephone - a1100, analog corded 1-line hotel telephone - a1210/cl-a1110, analog corded 2-line hotel telephone - a1220, analog corded trimstyle hotel telephone - a1310/a1311, analog cordless 1-line hotel telephone - a1410, a (56 pages)
Analog classic series, analog corded 1/2-line/trimstyle lobby hotel telephone, analog cordless charging base, analog cordless 1/2-line accessory handset (42 pages)
Important safety instructions The applied nameplate is located at the bottom or rear of the product. When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury, including the following: 1.
Page 3
during an electrical storm. There is a remote CA CAUTIONS risk of electric shock from lightning. • Keep small metallic objects such as pins and 16. Do not use the telephone to report a gas staples away from the handset receiver. leak in the vicinity of the leak.
Speakerphone ..........14 Message waiting indicator ......14 Play messages ..........14 Appendix ..........15 Troubleshooting ............ 16 VTech Hospitality Limited Warranty Program 18 Maintenance ............20 Disclaimer and Limitation of Liability....20 European Directives ..........20 Declaration of Conformity ........20 Disposal of batteries and product ....
Parts checklist Items contained in the telephone package: Parts included Model Model name number Base Stand | Telephone base with Telephone line Corded handset Wall Mount overlay cord Bracket Analogue Next Gen Corded NG-A3311 TrimStyle 1-Line Hotel Telephone EN - 5...
3. Plug the other end of the telephone line Installation cord to the telephone wall jack. Installation option - installing base stand for desktop To mount the telephone base on the base stand 1. Turn the telephone base over with the bottom side facing up.
4. Mount the telephone base on the wall by Installation option - converting positioning the eyelets on the telephone from desktop to wall mount position base and the mounting bracket against the To mount the telephone base on the wall mounting studs.
Page 10
Mounting bracket footprint dimension Unit: mm EN - 10...
Installation Notes Replacing coiled handset cord To replace the coild handset cord: Caution! Please be careful of sharp edges 1. Hold the handset upside down. of base stand that can cause harm during the installation process. 2. Press both thumbs down on the edge of the handset back cover near the back of the Avoid placing the phone too close to: earpiece, and slide the back cover upwards.
Set up Default settings are indicated by asterisks (*). Setting Options Adjustable by Handset earpiece volume 1, 2*, 3 User and administrator Speakerphone volume 1, 2, 3, 4*, 5, 6 User and administrator Ringer tone Tone 1*, Tone 2, Tone 3 Administrator only Disable voicemail voltage detection, Periodic low voltage pulse detection...
Page 13
Set up (Continued) Voicemail voltage detection There are 3 options to set the voicemail voltage detection at the bottom side of the telephone base. Jumper To disable the voicemail voltage detection: 1. Use a narrow object to unplug all the jumpers from the telephone base. To set the voicemail voltage detection by the periodic low voltage pulse detection method: 1.
Operation Mute To mute the microphone: Receive a call 1. During a call, press . The When there is an incoming call, the telephone illuminates when the mute function is turned rings and the MESSAGE WAITING LED flashes. on. You can hear the party on the other end To answer a call: but they cannot hear you.
Appendix Troubleshooting If you have difficulty with the telephones, please try the suggestions below. For customer service, call +44 (0)1706 694 070 or email ukca@trustdistribution.com. For corded telephone Question Suggestions • Make sure the telephone line cord is plugged firmly into the telephone wall jack. •...
Page 16
Question Suggestions • Make sure the telephone line cord is plugged in properly. • If other telephones in your hotel are having the same problem, the problem is in the wiring or telephone service. Contact your telephone service provider (charges may 4.
Page 17
Question Suggestions • Disconnect the telephone base from the telephone wall jack. Plug in a different 6. I hear other calls when using the telephone. telephone. If you still hear other calls, the problem is probably in the wiring or telephone service.
If VTech’s authorised service representative repairs the Product, new or refurbished replacement parts may be used. If the Product is replaced, it may be replaced with a new or refurbished Product of the same or similar design. Repair or replacement of Product, at VTech’s option, is the exclusive remedy.
Page 19
If the Product failure is not covered by this limited warranty, or proof of purchase does not meet the terms of this limited warranty, VTech will notify you and will request that you authorise the cost of repair and return shipping costs for the repair of Products that not covered by this limited warranty.
Avoid rough treatment for any loss or claims by third parties that may Place the handset down gently. Save the original arise through the use of this product. VTech packing materials to protect your telephone if Telecommunications Limited and its suppliers you ever need to ship it.
Disposal of batteries and product Product disposal instructions for business users ) ( These symbols on the products, If you wish to discard electrical and electronic packaging, and/or accompanying documents equipment, please contact your dealer or mean that used electrical and electronic supplier for further information.
Size Telephone base: 52.7 x 115.1 x 132.7 mm Corded handset: 203 x 48 x 20.5 mm Manufacturer VTech Telecommunications Limited Address: 23/F Tai Ping Industrial Centre, Block 1, 57 Ting Kok Road, Tai Po, Hong Kong EN - 22...