Dometic PerfectView CAM 360 Installation Manual page 36

Video system settings
➤ Enter the dimension W for the "WIDTH".
➤ Enter the dimension L for the "LENGTH".
➤ Enter the dimension O for the "OFFSET".
➤ Select "CALIBRATION".
If the message "DETECT CLOTH FAILED!!" is displayed:
➤ Select "CHECK CAM".
➤ Check whether:
– A strong shadow is on the calibration mat
– The complete calibration mat is not visible
– Poor light conditions or reflections are present
➤ Rectify the respective problems.
➤ Select "CALIBRATION" again.
✓ After the calibration, the display indicates "CALIBRATION SUCCESSFUL".
If you use the distance lines of the rear camera:
➤ Align the distance lines by adapting the parameter "AUX LINE START" (refer to
chapter "Setting a SINGLE CAMERA" on page 32).
Fine adjustment for offset
I
NOTE
For a fine adjustment in case of an offset, only change the parameters on
the screen. It is not necessary to align the calibration mats or cameras.
➤ Select "CALIBRATION".
If you detect an offset in the front measuring tape (fig. m, page 11):
➤ Change the "OFFSET" parameter.
➤ Select "CALIBRATION".
➤ Check the image.
➤ Repeat these steps until no offset is visible.
36
CAM360
EN