Dometic PerfectView CAM 360 Installation Manual page 35

CAM360
CALIBRATION
WIDTH
LENGTH
OFFSET
CALIBRATION
SAVE
Calibration
➤ Select "CHECK CAM".
✓ The display shows the camera image with a grid.
➤ Select the single camera views one at a time.
✓ There must be only a small gap visible between calibration mat and the edge of
the screen. It may be necessary to adjust the value of
"Setting BASIC VALUES" on page 30).
➤ Check whether the camera angles are set so that:
– The vehicle is visible at the bottom edge of the screen.
– The complete calibration mat can be seen.
– The rear grid of the calibration mat is parallel to the horizontal lines of the grid
(fig. l, page 10).
➤ If necessary, change the position of the calibration mat or the camera.
➤ Measure the dimensions W, L and O in mm (fig. k, page 10).
EN
2.500
10.000
4.000
CHECK CAM
Video system settings
"BV HEIGHT" (see chapter
35