Installing The Sweat Cover; Wrapping The Handlebar - Garmin TACX NEO BIKE PLUS Owner's Manual

Installing the Sweat Cover

The optional sweat cover is absorbent and can protect your trainer from corrosion caused by perspiration.
1 Place the loop around the saddle post.
2 Fasten the hook and loop straps around the handlebar.
TIP: You should hand wash the sweat cover after a few rides. For care instructions, see the back of the sweat
cover.

Wrapping the Handlebar

You should replace the handlebar tape if it is worn or uncomfortable. Sweat from your hands can cause the tape
to degrade. Garmin recommends wearing cycling gloves.
TIP: It's a good idea to replace the tape on one side first, so you can compare it to the other side.
1 Remove the bar plugs , and pull up the lever hoods .
2 Remove all existing handlebar tape and damaged electrical tape.
3 If necessary, use electrical tape to secure the shifter cables.
4 Wrap the handlebar with new tape.
5 Pull down the lever hoods, and replace the bar plugs.
Device Information 25