Table of Contents
Advertisement
Configuration
MAC Address
S/W Version
H/W Version
Active IP Address
Active Subnet Mask
Active Gateway
DHCP Server
Lease Time Left
Temperature
DHCP Enabled
Fallback IP Address
Fallback Subnet Mask
Fallback Gateway
Name
Password
Inactivity Timeout
SNMP enabled
SNMP Trap destination The IP address of the SNMP trap manager
SNMP Read community The community allowed for the SNMP [get] message
SNMP Write community The community allowed for the SNMP [set] message
SNMP Trap community The community used for the SNMP trap messages sent by the switch
Power Saving Mode
Apply
Refresh
Description
The MAC address factory configured for the switch
It can not be changed in any cases.
The firmware version currently running
The hardware version currently operating
Currently used IP address for the switch management
Currently used subnet mask for IP address for the switch management
Currently used gateway IP address for the switch management
Current IP address of the DHCP server
The time left for the lease IP address currently used
The junction temperature sensed in the main chip
Use DHCP to get dynamic IP address configuration for the device
IP address used when DHCP mode is not enabled
Subnet mask for IP address used when DHCP mode is not enabled
Default gateway IP address used when DHCP mode is not enabled
Set the system name for this switch unit
Note: It is suggested to give each device unit a system name as an alternative unique
identification beside IP address.
Set new password
Timeout for auto logout (unit: second)
Enable SNMP agent
Enable / disable power saving function
Click to apply the changes.
Click to refresh the page. Any changes made locally will be undone.
-26-
Advertisement
Table of Contents
