Making Management Connection; Reset Button; Led Indication - KTI Networks KTGC-221 Installation Manual

2.8 Making Management Connection

The device is featured to support web-based management and SNMP management. Use Cat.5 cable and
connect the management port to a TCP/IP network where the web management host and SNMP host are
located. The following figure illustrates a typical connection:

2.9 RESET Button

The button can also be used to restore the software configuration settings to factory default values.
The operations are:
Operation
Reset the device:
Press the button and release during operation.
Restore factory default:
Press the button until all LED blinks, then release.

2.10 LED Indication

LED Function
POWER Power status
MNGT Management port status
LINK RJ-45 copper port link
status
ACT. RJ-45 copper port activity
Function
All LEDs ON, then reboot the device.
The boot-up takes about 20 seconds and ends with
all LEDs OFF.
Restore all factory default settings.
Then, reboot the device.
State
ON The power is supplied to the device.
OFF The power is not supplied to the device.
ON The port link up
OFF The port link down
Blink Traffic activity status
ON The port link up
OFF The port link down
OFF No data traffic
-17-
Interpretation