Korg iM1 Owner's Manual page 43

CONTROLLER
In addition to MIDI keyboards, there are many MIDI control-
lers and control surfaces that can send a MIDI CC signal to
expressively alter certain sound-creation parameters in the
iM1.
Refer to M1 owner's manual PDF, page 33 "F7-2: JOY STICK"
PITCHBEND................................................................... [–12...+00...+12]
This parameter specifies the pitch bend range of an external
controller.
This setting may have no effect, depending on the SET-
TINGS mode "GLOBAL PITCHBEND Switch" setting.
(Refer to "GLOBAL PITCHBEND" on page 57)
VDF SWEEP INT ............................................................. [–99...+00...+99]
This parameter specifies the amount of VDF cutoff frequency
change produced by an external controller.
PITCH MG INT................................................................................[00...99]
This parameter specifies the degree to which an external con-
troller will affect the PITCH MG depth.
PITCH MG FREQ/PITCH MG TIMES ....................................................... [0...3]
This parameter specifies how an external controller will affect
the PITCH MG speed as a ratio relative to the "FREQ/TIMES"
value of the OSC page.
This setting will be either PITCH MG FREQ or PITCH MG
TIMES, depending on the OSC page "TEMPO SYNC" setting.
Available Parameters by Mode
VDF MG INT .................................................................................. [00...99]
This parameter specifies the degree to which an external con-
troller will affect the VDF MG depth.
VDF MG FREQ/VDF MG TIMES..............................................................[0...3]
This parameter specifies how an external controller will affect
the VDF MG speed as a ratio relative to the "FREQ/TIMES"
value of the VDF page.
This setting will be either VDF MG FREQ or VDF MG TIMES,
depending on the VDF page "TEMPO SYNC" setting.
VDA MG INT .................................................................................. [00...99]
This parameter specifies the degree to which an external con-
troller will affect the VDA MG depth.
VDA MG FREQ/VDA MG TMES ..............................................................[0...3]
This parameter specifies the how an external controller will
affect the VDA MG speed as a ratio relative to the "FREQ/
TIMES" value of the VDA page.
This setting will be either VDA MG FREQ or VDA MG
TIMES, depending on the VDA page "TEMPO SYNC" setting.
43