Korg iM1 Owner's Manual page 35

OSC 1/OSC 2/DRUMS ........................................................ [DISABLE, ENABLE]
Use this parameter to choose which oscillator(s) the PICH
MG modulation will be applied to.
WAVEFORM .......................................................................[SIN...RANDOM]
This parameter selects the modulation waveform.
KEY SYNC........................................................................ [DISABLE, ENABLE]
Key Sync allows the phase of the modulation generator to
occur in exactly the same position with each new note-on
message. Without Key Sync, the modulation generator will
continue to vary its phase based on the modulation speed.
ENABLE: Key Sync is on
DISABLE: Key Sync is off
INTENSITY ....................................................................................[00...99]
This parameter specifies the depth of modulation.
DELAY ..........................................................................................[00...99]
This parameter sets the time interval between the note-on and
when the modulation is applied.
TEMPO SYNC ................................................................... [DISABLE, ENABLE]
Tempo Sync allows the modulation speed to be musically
related to the tempo.
DISABLE: Tempo Sync is off
ENABLE: Tempo Sync is active
FREQ/TIMES.......................................................................[00...99/1...16]
TEMPO SYNC DISABLED: Frequency [00...99]
Available Parameters by Mode
This parameter will directly specify the MG frequency.
TEMPO SYNC ENABLED: Times [1...16]
This parameter will set the MG frequency in conjunction with
the BASE NOTE setting.
BASE NOTE ...............................................................................[1/1...1/32]
TEMPO SYNC DISABLED:
This parameter is ignored.
TEMPO SYNC ENABLED:
1/1 equals a whole note, 1/32 equals a thirty-second note, etc.
This parameter will set the MG frequency in conjunction with
the BASE NOTE setting. One cycle of the MG will be equal to
the value specified in FREQ/TIMES x the BASE NOTE value
relative to the synchronized tempo.
For example, when the BASE NOTE value is set to 1/4 (quar-
ter note), the resulting beats per MG cycle will be:
• TIMES = 1 (one beat per MG cycle)
• TIMES = 2 (two beats per MG cycle)
• TIMES = 4 (four beats per MG cycle)
Conversely, when the BASE NOTE value is set to 1/16 (six-
teenth note), the resulting MG cycles per beat will be:
• TIMES = 1 (four MG cycles per beat)
• TIMES = 2 (two MG cycles per beat)
• TIMES = 4 (one MG cycle per beat)
35