Appendix 4: Replacing The Hard Drive; Removing The Hard Drive - Lorex L114V251 Instruction Manual

L114v series digital video surveillance recorder with motion detection and audio recording

Hide thumbs Also See for L114V251:

Table of Contents

Appendix 4: Replacing the Hard Drive

The system comes with a pre-installed 3.5" SATA hard drive, however the unit will work with a

replacement single hard drive (up to 1 TB).

Note: Make sure that the system is OFF and the power cable has been disconnected before

changing the hard drive.

To remove the hard drive:

1. Remove seven screws from the cover of the

housing: three from the top half of each side

panel; one from the top near the rear panel.

2. Gently lift off the cover.

3. With your hand supporting the hard drive, turn

the unit upside down. Remove the four

mounting screws from the bottom of the unit.

Turn the unit right side up.

4. Disconnect the power and data cables.

5. Remove the hard drive.

Note: Make sure to keep the two sets of screws

(cover, mounting) in a safe place.

Figure 21.0 Remove seven screws from cover

Figure 21.1 Remove cover.

Figure 21.2 Support the HDD with your hand and remove

mounting screws.

Figure 21.3 Carefully remove the HDD from housing.

Table of Contents