Table of Contents
Advertisement
Password Change
Use Hard Disk Setup to change your system
password (by default, 111111).
Figure 16.2 Password Change screen
To change your system password:
1. From the Hard Disk Setup menu, select
Password Change and press
2. Enter your current password.
Note:
Enter
your
password. Select Shift to view uppercase
characters and symbols.
3. Re-enter your new 6-character password
to confirm. The password screen closes
and returns you to the System menu.
4. Press
until the Exit menu appears.
Select Save & Exit and press
save your settings.
ATTENTION: You must save your
settings from the Exit menu for your new
password to take effect.
Time Set
You should always set the date and time when
first starting up the system. For details on
setting the time, see "Setting the Date and
Time" on page 12.
.
new
6-character
to
Event List
You can access the Event List from the System
menu. For more details on using the Event List,
see "Event List" on page 17.
Loss Alarm
Enable/disable the buzzer when a camera is
disconnected.
To enable/disable the loss alarm:
1. From the System menu, select Loss
Alarm and press
Note: If On, a short buzzer will sound if a
camera is disconnected; the loss icon will
also appear in the top-right corner of the
affected channel. If Off, the buzzer will not
sound, but the loss icon will appear in the
top-right corner of the affected channel.
F/W Upgrade
Firmware upgrades can provide improved
functionality to your system. You can download
these free upgrades from
Note: You must disable recording on the
system prior to updating the firmware.
Figure 16.3 Firmware upgrade screen
To upgrade firmware:
1. Download the update from
www.lorexcctv.com
firmware carries the file extension,
Using the Setup Menu
to select On/Off.
www.lorexcctv.com
to your PC. The
.FWI
25
Advertisement
Table of Contents
