When Access Key Does Not Operate Properly - Subaru Outback 2015 Manual

ignition switch illuminates in orange.
Power
Indicator color
status
Power is turned
OFF Turned off
The following
systems can be
ACC Orange
audio and ac-
cessory power
Orange
(while engine is
All electrical
stopped)
ON systems can be
Turned off
(while engine is
running)
CAUTION
. When the push-button ignition
switch is left in "ON" or "ACC"
for a long time, it may result in
vehicle battery discharge.
. Do not spill drinks or other
liquids on the push-button igni-
tion switch. It may cause a mal-
function.
. Do not touch the push-button
ignition switch with a hand soiled
with oil or other contaminants. It
Instruments and controls/Push–button ignition switch (models with push–button start system)
may cause a malfunction.
. If the push-button ignition switch
does not operate smoothly, stop
Operation
the operation. We recommend
that you contact a SUBARU deal-
off. er immediately.
. If the push-button ignition switch
does not illuminate even when
used:
the instrument panel illumination
is turned on, we recommend that
outlet.
you have the vehicle inspected at
a SUBARU dealer.
. If the vehicle was left in the hot
sun for a long time, the surface of
used.
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
NOTE
. In CVT models, the push-button
ignition switch cannot be switched to
"OFF" when the select lever is in a
position other than "P".
. When operating the push-button
ignition switch, firmly press it all the
way.
. If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
. If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
! Battery drainage prevention func-
tion
When the push-button ignition switch is
left in "ACC" or "ON" for approximately 1
hour, the push-button ignition switch will
be automatically switched to "OFF" to
prevent the battery from going dead. (In
CVT models, this function is activated
when the select lever is in the "P"
position.)
& When access key does not
operate properly
Refer to "Access key – if access key does
not operate properly" F9-29.
3-7