Getting Started - Lorex DXR43000 Series Instruction Manual

4

GETTING STARTED

1. Connect the AC Power Cord to the Power Adapter and plug it into an
electrical outlet.
2. Connect up to 4 cameras to the BNC video inputs on the back of the DVR.
3. Plug in the power adapter to the back panel. The Red LED indicator will
illuminate and the DVR will be in the standby mode
4. The following messages appear when the power is ON successfully.
POWER ON CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
HDD IDENTIFY CHECK _ _ _ _ _ _ _ _ _ __ _ _ _
HDD R/W CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __
MODEL
HDD LBA
Note: The system is only checking for a MASTER HDD. Install the Slave HDD onto the
DVR (if using a Slave HDD), set up the Slave HDD in the MAIN MENU CONTROL
settings and restart the DVR.
Note: If the HDD is not properly connected a FAIL message appears. Try reconnecting
the HDD and turn on the power.
Dynamic IP Request
*** MASTER HDD DETECT ***
:XXXXXXXXXXXXXXXXXXXXXX
: XXXXXXXXXXXXXXXXXXXXXX
HDD SPACE : XXX GB
6
OK
OK
OK
OK
100 %