Table of Contents
Advertisement
data transmission, can be set to OFF, 2400, 4800, 9600, or
19200.
(iii) PASSWORD SET : If you select [Y], you will need to input a
password when you enter the Main Menu. Use to change your
password for accessing the Menu. The password must be 4
digits. The default Password is "0000".
Selecting [N] will allow you into the menu without a password.
NOTE NETWORK CONFIGURATION (Part of SYSTEM SET (ll))
(iv) NETWORK (TCP/IP): The User can set the network for OFF,
DYNAMIC IP or STATIC IP. The default value is "DYNAMIC IP".
(v) USER ID/PASSWORD: The User can set a password for the
Master ID and account. The Master ID should be 5 digits in
English, and the Password should be a 5 digit alphanumeric
combination.
Default value - ADMIN / ADMIN.
(vi) GUEST PASSWORD: The User can set a password for the
GUEST account. Maximum 5 digits.
Default value - GUEST.
The Master User has full access to all the functions on the Network but
NOTE
the Guest User has limited access to the functions. The GUEST can see
only cameras.
(vii) IP ADDR :
Default value – 192. 168. 001. 150
(viii) SUBNET :
Default value - 255.255. 255. 000
(ix) GATEWAY : Enter the Default Gateway.
Default value – 192. 168. 001. 001
(x) PORT :
Default value – 5000
8.
HDD / REC SET
your Hard Disk Drive.
Enter the DVR IP address.
Enter the Subnet Mask.
Enter the Default port.
This sub-menu allows you to set the Record parameters for
-
22
Advertisement
Table of Contents
