Use And Operation - Scotsman Prodigy ELITE A Series Installation And User Manual

Hide thumbs Also See for Prodigy ELITE A Series:
Table of Contents

Advertisement

MC0322 through MC1030
Air and Water Cooled User Manual

Use and Operation

Once started, the ice machine will automatically make
ice until the bin or dispenser is full of ice. When ice
level drops, the ice machine will resume making ice.
Caution: Do not place anything on top of the ice
machine, including the ice scoop. Debris and moisture
from objects on top of the machine can work their way
into the cabinet and cause serious damage. Damage
caused by foreign material is not covered by warranty.
There are five indicator lights at the front of the
machine that provide information on the condition of
the machine.
Indicator Lights:
Power
Status
Water
Clean (De-scale & Sanitize)
Bin Full
Power
Steady
Normal
Green
Blinking
Self Test
Green
Failure
Blinking
-
Red
Yellow
-
Blinking
-
Yellow
Light off
No power
If the Water light is on, the machine has sensed a
lack of water. Check the water supply to the machine.
The water could have been shut off or the water filter
cartridges might need to be changed.
Indicator Lights & Their Meanings
Status
Normal – bin full or
making ice
Switching on or off
Diagnostic shutdown or, if
making ice, temperature
sensor failure
-
-
Switched off
If the Clean light is solid yellow, the machine has
determined that it needs to be cleaned. Contact an
authorized Scotsman service agent and have the
machine cleaned, de-scaled and sanitized.
During normal operation, if the Clean light begins to
blink yellow, the machine in Preservation mode, which
initiates a timed freeze in response to short freeze
errors. Contact an authorized Scotsman service agent
to service the machine immediately. It is likely that
the machine needs to be cleaned (de-scaled and
sanitized), but may need additional service.
Water
De-Scale & Sanitize
-
-
-
-
Lack of water
-
-
Time to de-scale and
sanitize
-
Preservation Mode is
active or clean cycle is
in progress
Normal
Normal
Note: A Component Indicator Light switches ON to
indicate that the component is operating.
Note: There are two Curtain Switch lights, SW1 and
SW2. These single plate models have one curtain
switch light on all the time, as a curtain switch light is
ON when a curtain is either open or not present.
June 2022
Page 16
Bin Full
Bin is full
Bin is not
full

Advertisement

Table of Contents
loading

Table of Contents