On-Screen Display - Lorex LW2602 Instruction Manual

On-Screen Display

On-Screen Display
1. Signal Indicator – The signal indicator
shows the strength of the signal being
received from the camera.
The number of bars in the Signal Indicator
shows the strength of the signal – One or
No Bars indicates the signal is poor, and 4
bars indicate a very strong signal.
Note: Signal Indicator not shown while
in Quad Mode.
ATTENTION: If signal is low (e.g. 1 or 2
bars) adjust the antennas, or reposition
the cameras or receiver for best
performance.
2. Channel Indicator – Displays the current channel
number. Press the CH button on the Receiver to
switch between available cameras.
Note: Channel Indicator not shown while in Quad
Mode.
CH 1 CH 2
CH 4
CH 3
3. Status Indicator – The Status indicator message
"Connecting" appears when the receiver is trying to
locate a camera.
Note: There may be temporary signal losses for
less than 1 second, due to the connection retrieval
process between the Camera and Receiver (when
switching between channels). This normal and
should not be considered a defect.
14
1 2
Figure 6.0 On-screen display
Figure 6.1 Quad split-screen view
3
Figure 6.2 Connecting message