Installing The Wireless Receiver; On-Screen Display - Lorex Vantage LW2220 Instruction Manual

Installing the Wireless Receiver

5. Installing the Wireless Receiver
1 Screw the wireless antenna to the back of the receiver.
2 Connect the yellow video cable and white audio cable (mono) to your TV, DVR, or observation
system.
• Use the RCA/BNC adapter (included) to connect the video cable to a BNC port.
3 Connect the power cable to the power adapter. Plug the power adapter into a power outlet or
surge protector.
4 Place the receiver in a place that will have clear reception to your camera

5.1 On-Screen Display

1
Signal Indicator
1 Signal Indicator: The signal indicator shows the strength of the signal being received from
the camera. The number of bars in the signal indicator shows the strength of the signal. 
One or no bars indicates the signal is poor. Four bars indicate a very strong signal.
2 Status Indicator: The status indicator message "No Signal" appears when the receiver is
trying to locate a camera.
ATTENTION:If the signal is low (e.g. 1 or 2 bars) adjust the antennas or reposition the
camera or receiver to improve signal strength.
1. Avoid installing in a location which requires the wireless signal to pass through cement, con-
crete, and metal structures. This will reduce the range of transmission.
6
Before powering on the receiver, make sure to first connect and
power on the camera. This will ensure a proper connection.
2
Status Indicator
1
.