Adding Cameras; Using Auto-Scan - Lorex LW2602 Instruction Manual

Adding Cameras

The System comes with cameras that have already been paired up with the receiver. The Pairing
Function assigns each camera to a different channel on the Wireless Receiver (up to 4 Cameras), and is
necessary for connecting additional cameras. By default, the cameras included with the system appear on
channels 1 and 2 on the wireless receiver.
Note: It is highly recommended to pair additional cameras to the receiver before permanently
mounting the cameras.
1. Connect the power cable from the camera to
the cable from the Power Adaptor; plug the
Power Adaptor into an outlet or surge protector.
2. Press the CH button on the Wireless Receiver
to select an empty channel.
3. Press and hold the CH button for 5 seconds to
activate pairing function. The on-screen
displays informs you that you have 30 seconds
to press the yellow pair button on the camera
(see Figure 5.1).
4. Press and hold the Yellow Pair button
extending from the camera. You must press the
Yellow Pair button from the camera within 30
seconds of pressing the CH button on the
Wireless Receiver. If pairing is successful, live
video from the camera will immediately appear
on the monitor.

Using Auto-Scan

Auto-Scan automatically switches between channels 1~4.
Press the CH button to turn on Auto-Scan (CH1~4> Auto-
Scan> Quad).
You can also disable Auto-Scan for individual channels. This
allows you to customize viewing of the connected cameras.
To disable Auto-Scan:
1. Make sure the Wireless Receiver and cameras are
fully connected and powered on.
2. Press the CH button to select the channel you wish to
remove from Auto-Scan.
3. Press and hold the RES button until the on-screen
display indicates that Auto-Scan has been turned OFF
for that specific channel.
Note: Repeat step 3 to turn Auto-Scan ON.
Figure 7.0 CH button on the LCD Wireless
Receiver
Figure 7.1 Pair button extending from camera
Figure 8.0 Auto-Scan turned OFF for
Channel 1.
Adding Cameras
15