Installing The Camera - Lorex LW2602 Instruction Manual

LCD Receiver / Monitor

Installing the Camera

To install the camera:
1. Use the included mounting screws to
mount the stand to the mounting
surface:
• Mark the position of the screw holes
on the wall.
• Drill holes and insert the drywall
plugs as needed.
• Firmly attach the stand to the wall
using the provided screws.
2. Slide the sunshade on the camera
body.
3. Screw on the antenna to the back of
the camera.
4. Attach the camera to the mounting
stand. Tighten the thumbscrews to
secure the camera to the stand.
Adjust the angle of the camera until
the desired view is set.
5. Connect the power cable from the
camera to the power adaptor to
power on the camera.
Note: You can install additional
cameras (maximum of 4
cameras).When adding cameras that
were not included in the original box,
you will need to pair up the cameras
with the receiver. Refer to the camera
pairing section of this manual for more
details.
10
Figure 2.0 Attach stand to mounting surface
Figure 2.1 Attach the camera to the stand